Flashing Ghost Atto/Zepto RX's¶
Target: GHOST_ATTO_2400_RX_via_STLINK
Device Category: ImmersionRC Ghost
Device: GHOST ATTO 2400 RX
Flashing the Ghost RX's is currently a 1 WAY flash once you flash ExpressLRS to these RX's you will not be able to use them with Ghost TX. You will need a StLink V2
to flash the RX's
- Wire
3.3v
,GND
,CLK
, andDIO
to their respective pins on the RX from the StLink. - Select the
GHOST_ATTO_2400_via_STLINK
target. - Set your Firmware Options and click on
Build and Flash
. - Connect your receiver to your Flight Controller as normal (i.e. Rx to Tx, and Tx to Rx);
Subsequent Firmware Updates can now be done using via_BetaflightPassthrough
target.