Siyi FR Mini
Targets:
FM30_RX_MINI_via_STLINK
(First-time Flash)FM30_RX_MINI_via_BetaflightPassthrough
(Updates)
Note: only guaranteed to work on the v3.0 of the receiver.
Initial Flashing¶
The only way to flash the FR Mini is using STLINK. Note this is a one-way process, there is no returning to the stock firmware after flashing.
- Connect wires to DIO (SWDIO), CLK (SWCLK), RST, and GND to the header points on the RX
- Attach 3.3V to the VDD pad on the flashing header. Do not connect 5V here!
- Flash using the
FM30_RX_MINI_via_STLINK
target in the ExpressLRS Configurator
For more information and troubleshooting of the STLINK connection, see the detail on the FM30 Initial Flashing page.
Once flashing is complete, wire the receiver to your flight controller using the images below.
Flight Controller | FR Mini Receiver |
---|---|
5V | VDD |
GND | GND |
RX | TX2 |
TX | RX2 |
Thank you to @JupaCreations
Updating via Passthrough¶
Updating is done via Betaflight Passthrough with the receiver wired to the flight controller. Be sure the transmitter is off, use the FM30_RX_MINI_via_BetaflightPassthrough
target in the ExpressLRS Configurator, then click on Build and Flash.