Binding can be done with either a hard coded unique binding phrase or in a more traditional way where you put the receiver and transmitter into bind mode, and they link up. There is no reason to use traditional binding if you're flashing both your TX and RX firmware anyway. If you used a bind phrase in your user defines, there is no need to read this article. Proceed to the next section. If not, here is how to bind an ELRS TX and RX.
You need to have a unique binding phrase in the
user_defines.txt file or entered in the "Custom Binding Phrase" box in the Configurator. After flashing your TX and RX, they will bind automatically. Is my binding phrase a secret?
-DMY_BINDING_PHRASE="default ExpressLRS binding phrase"
For traditional binding, the binding phrase must be commented out in user_defines on the RX.
- Power off your transmitter/radio.
- Powercycle the receiver 3 times (unplug-replug LiPo).
- Make sure the LED is doing a quick double blink, which indicates the receiver is in bind mode.
- Power up your transmitter/radio and use the [BIND] button on the ExpressLRS Lua script, which sends out a binding pulse.
- If the receiver LED turned into a solid light, it's bound!
Important: If the RX firmware has a bind phrase, the RX will never enter binding mode using the above procedure. It must be flashed without a binding phrase to do traditional binding. Why would you not use a bind phrase though if you're already having to flash the RX anyway?
Go to the
Telemetry Page of your model setup and try to find new sensors. If the telemetry data shows up then you are connected!